Tristan Croll
17th June 2000, 08:20 PM
Does anyone know where I can get some faceplates made to order? My lathe is a huge old cast iron thing (no discernable brand) that I managed to get (for $50!!) from my old high school when they upgraded their manual arts centre. However, it only came with one large faceplate and a couple of small ones with holes for two or three small screws, and an expanding chuck.
For most of my purposes, this is completely adequate, however I have no way of cleaning up the base of my bowls since I have no spare faceplate. Also, there are no faceplates which will fit the outboard side.
Thanks.
------------------
Tristan Croll
cogito cogito, cogito ergo sum
----
I think that I think, therefore I think that I am
For most of my purposes, this is completely adequate, however I have no way of cleaning up the base of my bowls since I have no spare faceplate. Also, there are no faceplates which will fit the outboard side.
Thanks.
------------------
Tristan Croll
cogito cogito, cogito ergo sum
----
I think that I think, therefore I think that I am