PDA

View Full Version : segmented oak platter



Ad de Crom
10th Jun 2010, 08:37 PM
This is a segmented oak platter made for the wedding of the daughter from my sister-in-law.
Had to work hard to get it done, tomorrow is the wedding, so just in time.
This platter has a diameter of 305mm, almost the maximum diameter I can handle on my lathe. As usual finished with blanc transparent acrylic stain decoration on waterbase.
Comments or critique are welcome.
Cheers, Ad

wheelinround
10th Jun 2010, 09:01 PM
Hi Ad you have been a busy lad must be fine weather over there for so much shed time.

Now I can see where to use some left over Oak not going to look as impressive I can assure you:2tsup:

powderpost
10th Jun 2010, 09:31 PM
G'day Ad, That is a nice platter. Nice variation in the but joints. :2tsup:
Jim

artme
10th Jun 2010, 10:48 PM
Nice segmenting Ad, and a nice platter!!!:2tsup::2tsup::2tsup:

The overall effect for me is that of a spiderweb.

orificiam
10th Jun 2010, 10:51 PM
Congratulation Ad I'm sure the platter will be well received.
Cheers Tony.:2tsup:

bowl-basher
11th Jun 2010, 10:12 AM
As usual beautiful work old friend
:2tsup::2tsup::2tsup::2tsup:

Graham

Ad de Crom
11th Jun 2010, 07:17 PM
Thanks all for your nice comments, always good for this old fellow :D
Ad

Hardenfast
11th Jun 2010, 08:11 PM
Very nice mathematics, joinery and turning, Ad. If you don't mind me asking, how did you cut & join the rounded centre section?

Wayne

Ed Reiss
12th Jun 2010, 12:16 PM
Turned out well Ad...I like the rim treatment :2tsup: