echnidna
29th October 2004, 11:46 PM
My 12 1/2" thicknesser is an old Carbatec CT318.
I dont think the DC extractor accessory (chute or hood or whatever its called) is available any more for this old model so I will make one.
I have a feeling that the ratio of the taper over its length is relatively important though probably not very critical
Can someone with a 12 1/2" thicknesser (make unimportant) give me the rough dimensions of their thicknessers hood please. If I copy something that works Ok I should get it right first go.
I dont think the DC extractor accessory (chute or hood or whatever its called) is available any more for this old model so I will make one.
I have a feeling that the ratio of the taper over its length is relatively important though probably not very critical
Can someone with a 12 1/2" thicknesser (make unimportant) give me the rough dimensions of their thicknessers hood please. If I copy something that works Ok I should get it right first go.