rod1949
11th December 2010, 09:58 PM
I've had four of these table legs since about 1990 (purchased and stored and wrapped in gladwrap). I'm now making the top that these legs will support.
I want to have the square edge ledge at the top of the reeded fluting rounded over (without any chipping or splintering being done) as well as some other minor touch ups done on each leg. So are there any people with lathes here in Perth and close to me that can assist. I don't expect it to be done for free.
Thanks
Rod
I want to have the square edge ledge at the top of the reeded fluting rounded over (without any chipping or splintering being done) as well as some other minor touch ups done on each leg. So are there any people with lathes here in Perth and close to me that can assist. I don't expect it to be done for free.
Thanks
Rod