PDA

View Full Version : I'm Impressed



smidsy
10th Nov 2004, 07:07 PM
Went up to Carbatec today to get a Vicmarc screwplate - I figure I can use it with the clone chuck until I get a Vicmarc.
I had only seen this beast in the catalogue but was buying it based on the Vicmarc rep.

Damn it's a solid but of kit - a nice thick plate and a screw that leaves the clone for dead in size, quality and thread.
If the Vicmarc chuck is like that I'm drooling already.
Cheers
Paul

gatiep
10th Nov 2004, 07:58 PM
It's the same quality mate! You'll be over the moon with it when you get one.

Ave a gud one
:)

smidsy
10th Nov 2004, 08:24 PM
Hei Joe,
I just wish Vicmarc would hurry up and send them over. I spoke to Brett on e-mail yesterday and it's looking like next week for Carbatec getting some.

If I had $20 to spare I'd be tempted to get them to throw one in an airbag.
Cheers
Paul