PDA

View Full Version : an update on the tools tried at Wheelins



hughie
23rd April 2011, 05:40 PM
This a further updated version of Munro/Proforme hollower trialed at Wheelinround.

It use a double sided McJings cup cutter M2 HSS. Shaft is 12mm and hardened to give it more stiffness approx. It will extend about 375mm or 14", handle is foam covered stainless tube 12" long

The shorter shaft is for the hook tool, done in stainless. The hook tool I will shorten down some before I use it.

TTIT
23rd April 2011, 09:52 PM
Looks functional enough Hughie - how did it go in the trials - or have I missed something :? Is there a gap/chute on the other side for the chips to eject from????

hughie
23rd April 2011, 11:41 PM
Looks functional enough Hughie - how did it go in the trials - or have I missed something :? Is there a gap/chute on the other side for the chips to eject from

Here you go Vern :2tsup: I may open it up further as I try it out. The previous one had more material on the guard than this one and it passed muster

wheelinround
24th April 2011, 10:44 AM
Nice improvements Hughie :2tsup: