PDA

View Full Version : Combined Saw and Thicknesser Bench.



CHJ
15th December 2004, 02:34 AM
Just in case the idea is of interest to others with limited workshop space.

Attached views of saw bench with thicknesser mounted below, note castors at rear that enable moving by lifting front edge.
Also note my method of stowing long equipment cables (saves cutting them short in case of future move) Fold cables (not coil) and push into a short length of plastic rainwater piping mounted on bench.

(My woodwork has been restricted to the garage workshop since tealeaves found they could get to my 24X10 ft alarmed workshop at the end of my property with a 4X4 and borrow gear quicker than we could respond at 3 am in the morning.)