morrisman
4th September 2012, 10:36 AM
Hi
I came across this in my latest book.. SHOP THEORY by James Anderson , 1968 edition , ex Bryan college Dayton Tennessee
It describes the recommended method of honing an edge on a lathe tool . They write , to hone and edge, get it about 1/32" wide at an angle that is 1 to 3 degrees less than the main angle
Mike
I came across this in my latest book.. SHOP THEORY by James Anderson , 1968 edition , ex Bryan college Dayton Tennessee
It describes the recommended method of honing an edge on a lathe tool . They write , to hone and edge, get it about 1/32" wide at an angle that is 1 to 3 degrees less than the main angle
Mike