AndrewHavryliv
25th March 2005, 01:27 PM
Does anyone know where you can obtain or have made up a router nut/collet that can be attached to the (metric) threaded spindle on the 18000RPM end of a Ryobi Radial Arm Saw. Ryobi no longer supply the part, but with it, the saw would make a great overhead router!
Thanks, Andrew
bob w
29th March 2005, 09:21 PM
:confused: :confused:
Andrew
Sorry to take so long to respond but I have not had time to look at this forum.
Are you sure Ryobi is not supplying this part as it still appears on their parts list.Who have you asked and what was their reply? My parts list is in my workshop which is 70 metres from the house and is locked so I will check it in the daylight tomorrow and make some enquiries on your behalf.
Regards
Bob :) :)
AndrewHavryliv
29th March 2005, 10:32 PM
Bob,
I checked with Ryobi service in Sydney this morning. They advised they had a record of the part, but that there was no stock and that it is no longer available.
Andrew