kenny_10
1st May 2014, 10:02 PM
Hi guys.
Picked up this motor to run a small metal lathe and want to see if it goes..but I am a bit confused as to how to wire it up.
It has 4 terminals under the cover marked A, B, C and D with the earth on the outside of the body.
Cheers.. Ken.
ADDED BY ADMIN
DISCLAIMER
No liability is accepted by UBeaut or the Wood Working Forum's administrators
or moderators for advice offered by members posting replies
or asking questions regarding electrical work.
We strongly advise contacting a Licensed Tradeperson for all electrical work.
WARNING
Information supplied within posts is not to be considered as detailed formal instructions to complete a task.
Members following such information do so at their own risk
Picked up this motor to run a small metal lathe and want to see if it goes..but I am a bit confused as to how to wire it up.
It has 4 terminals under the cover marked A, B, C and D with the earth on the outside of the body.
Cheers.. Ken.
ADDED BY ADMIN
DISCLAIMER
No liability is accepted by UBeaut or the Wood Working Forum's administrators
or moderators for advice offered by members posting replies
or asking questions regarding electrical work.
We strongly advise contacting a Licensed Tradeperson for all electrical work.
WARNING
Information supplied within posts is not to be considered as detailed formal instructions to complete a task.
Members following such information do so at their own risk