Christos
6th March 2015, 02:30 PM
I had a thought about making something like a cookie jar shape. The original intention was to make it more artistic than functional. It is not quite there as an artistic piece. The walls are about 5 to 7mm thick as I did not hollow the inside enough. It started to crack so I added some thin CA glue and stopped at that point. Finished the sanding up to 400grit and started on the lid.
The lid is made from a contrasting piece that originally was a little bit lighter than what the photos show. It has a slight inward taper at the edge and a slight hollow on the top and inside. It was a very tight fit so a sanded it a little and now it is very loose. :doh:
The finish I used was 2 coats of Danish Oil. I was going for a matte finish.
All comments are welcome, good and bad.
341673 341674 341675 341676
With out comments I may not improve.
And yes the bowl has a hole in it. :innocent:
The lid is made from a contrasting piece that originally was a little bit lighter than what the photos show. It has a slight inward taper at the edge and a slight hollow on the top and inside. It was a very tight fit so a sanded it a little and now it is very loose. :doh:
The finish I used was 2 coats of Danish Oil. I was going for a matte finish.
All comments are welcome, good and bad.
341673 341674 341675 341676
With out comments I may not improve.
And yes the bowl has a hole in it. :innocent: