chuck1
15th May 2015, 09:14 AM
These are front legs for dining chairs timber is mahogany
I was a bit nervous starting this job as there was no spares so no room for error.
Mainly with the major and minor diameter so close to a square shoulder.
it seemed to take longer turning the little buttons with dowels to put on the big bead. It was handy having a indexing pin.
the customers wanted to do the fluting on the taper himself. Which was fine by me.
I now have a jig to flute and reed .
thanks for looking
I was a bit nervous starting this job as there was no spares so no room for error.
Mainly with the major and minor diameter so close to a square shoulder.
it seemed to take longer turning the little buttons with dowels to put on the big bead. It was handy having a indexing pin.
the customers wanted to do the fluting on the taper himself. Which was fine by me.
I now have a jig to flute and reed .
thanks for looking