PDA

View Full Version : Dynalink spur drive centre



powderpost
25th May 2015, 06:04 PM
The a rep from the local mens shed has asked me to find a spur drive for a Dynalink lathe model 190+93-01035. It was given to them. Can anybody tell me where to get that spur drive please?

Jim

Rod Gilbert
25th May 2015, 07:01 PM
Hi Jim,
I think that lathe is the standard boat anchor type sold under many different brands(thin square tube bed) I have one under the house the son inlaw gave me not sure if I have the spur drive I will have a look in the morning and let you know.
Regards Rod.

powderpost
26th May 2015, 06:37 PM
Rod, thanks for the reply. The spur drive is a threaded type, like a nut, not a morse taper. The thread is 20mm, I don't know what the pitch is though.

Jim

Rod Gilbert
27th May 2015, 08:15 AM
Hi Jim,
It took a bit longer than I thought to find the spur but it is now in my hand and as you described screw on type if you could PM me an address I will get it in the post for you.
Regards Rod.

powderpost
27th May 2015, 09:49 AM
Thanks Rod, PM sent.

Jim