NeilS
30th June 2016, 03:55 PM
I make an individual knife blocks to go with a good knife that is given as a gift for special occasions.
Here is one of my designs; turned offset, the blade slot is then cut on bandsaw and an Ebony trim added to close off the back of the sawn slot. The wood is Buloke.
386333 386334 386335
I've also done variations of this, like three sided, with one side narrower than the other two. Some just have a single Ebony peg across the back of the open slot to hold the blade in place.
There must be endless variations. Does anyone else have a design of theirs that they would like to share?
Here is one of my designs; turned offset, the blade slot is then cut on bandsaw and an Ebony trim added to close off the back of the sawn slot. The wood is Buloke.
386333 386334 386335
I've also done variations of this, like three sided, with one side narrower than the other two. Some just have a single Ebony peg across the back of the open slot to hold the blade in place.
There must be endless variations. Does anyone else have a design of theirs that they would like to share?