Dust bag & Blade Height Winder Problem

[JimG]

Just purchased Workcentre 2000, Triton Saw etc.

No problems with assembly or alignment but I find that the BHW seems to cause the Dust Bag to catch on the Saw mounting plate etc when lowering the blade.

Anyone else find this? Solution?

Thanks
Jim

[JimG]

Found cause of problem.
Small thread of cover caught by hex key in hole and this was causing cover to get wound up.(Me too)

Solution:- Gule a washer over hole and remove ALL material from hole.

Works great. Hope this may help someone.

Jim

[Kev Y.]

THANK YOU, THANK YOU, THANK YOU..

I did not have the same problem as you, but I did find it a problem locating the hole in the dust cover, now I dont..