Grant Cassar
30th June 2002, 10:30 AM
Hello all,
I'm very new to woodworking so this may be a very simple question. I have a series 2000 work table and the router table and would like to know if there is a simple and accurate way to get both sides of the timber parallel if the timber started off with a bow in it?
My dilemma is that when I run the timber along the guide fences of both the router and workbench I am replicating the bend that is against the fence.
Any advise is greatly appreciated
I'm very new to woodworking so this may be a very simple question. I have a series 2000 work table and the router table and would like to know if there is a simple and accurate way to get both sides of the timber parallel if the timber started off with a bow in it?
My dilemma is that when I run the timber along the guide fences of both the router and workbench I am replicating the bend that is against the fence.
Any advise is greatly appreciated