Tristan Croll
7th October 2002, 02:51 PM
Hi guys,
I finally got around to working on that rolling pin that SWMBO asked me to make out of redgum. Had it turned down to nicely round and was doing the final shaping when the base of my toolrest sheared clean off! The lathe is a bit of a no-name, so I was wondering what my chances are of finding a new one (hopefully a little more sturdy). The swing over the bed is a little less than 10cm.
Thanks,
Tristan
I finally got around to working on that rolling pin that SWMBO asked me to make out of redgum. Had it turned down to nicely round and was doing the final shaping when the base of my toolrest sheared clean off! The lathe is a bit of a no-name, so I was wondering what my chances are of finding a new one (hopefully a little more sturdy). The swing over the bed is a little less than 10cm.
Thanks,
Tristan