gtwilkins
25th November 2007, 05:43 PM
Recently moved and finally got the lathe wired up today, however when I turned on the VFD 2 little square red light lit up and when I shut down the code LU came up.
Lathe runs both forward and reverse but when I shut down the VFD it made a funny noise.
Any ideas gratefully accepted and is it safe to run lathe like this or does it indicate a problem with the VFD.
Thank you, Trevor
Lathe runs both forward and reverse but when I shut down the VFD it made a funny noise.
Any ideas gratefully accepted and is it safe to run lathe like this or does it indicate a problem with the VFD.
Thank you, Trevor