PDA

View Full Version : Triton Biscuit joiner dust extraction



stephenmeddings
15th December 2003, 11:37 AM
Here is the start of a few dust extraction bits my brother Brian and I have been working on over the past few weeks. We have now finished them and thought we'd share them with everyone.

This one is for those with Triton Biscuit Joiners. We both tend to only use one side of the arm, so that leaves the other side free to use for extraction.

Where the hose normally connects we simply taped up as nothing was going to have a chance to get up there now.

We have two different designs:
1. Orange was made with flared out sides.
2. Blue has simple straight sides which makes it easier to build as you don't have to muck around with angles etc.

A small planer dust hood, some scraps of MDF and a longer 25mm M6 bolt is all this is needed.

stephenmeddings
15th December 2003, 11:39 AM
design 1: front

stephenmeddings
15th December 2003, 11:40 AM
design 1: side

stephenmeddings
15th December 2003, 11:41 AM
design 1: top

stephenmeddings
15th December 2003, 11:42 AM
design 2: side

stephenmeddings
15th December 2003, 11:43 AM
design 2: front