PDA

View Full Version : Chinese SuperNova2 Chuck



OGYT
9th February 2008, 11:54 AM
There is a comparison report on another forum, about the NZ and PRC made SuperNova2 Chucks. :D
Can I place a link to that thread on this forum? Or should I just copy and paste the report? :?
I can tell you that it is a really favorable report.:2tsup:

RETIRED
9th February 2008, 12:50 PM
You can paste the link up.

OGYT
10th February 2008, 05:20 AM
http://www.woodcentral.com/cgi-bin/turning.pl?frames;read=176869&v1=e2vrt43&v2=Freud+bits&v4=shellac&v5=dfrwq67

The above link will take you to the report on the Chineses made SuperNova2 Chuck.
Let me know what you think.

rsser
10th February 2008, 06:51 AM
Thanks Al.

Interesting.

Question is how consistent their quality will be.

hughie
10th February 2008, 08:34 PM
.
Question is how consistent their quality will be


Definitely Interesting, hmmm. Its a matter of quality control, If Teknatool can maintain control then the quality will follow.

I can remember when the Japanese started to make stuff, it was woeful.:no: Then it was Taiwan's turn, same woeful. :no:

It may well be just a matter of time before they also turn out quality on a regular basis.

Thanks for that Al................my turn :U