bill_h
1st May 2004, 01:24 AM
First of all, can I say how much I enjoy this forum (and how addictive it is!)
I have returned to woodworking after a sabbatical of some fifteen years and, like so many others I have read about on this bulletin board, I find it a wonderful way to spend the evenings and weekends.
I have the opportunity to purchase a thicknesser manufactured circa 1986. It's a heavy sucker (15" with a 3HP single phase induction motor). It seems to work well, but my initial cuts have a severe snipe on the leading edge
I'd like to be sure that I can set it up properly. Can anyone please point me in the direction of general setup instructions for this type of machine?
Thanks in advance
I have returned to woodworking after a sabbatical of some fifteen years and, like so many others I have read about on this bulletin board, I find it a wonderful way to spend the evenings and weekends.
I have the opportunity to purchase a thicknesser manufactured circa 1986. It's a heavy sucker (15" with a 3HP single phase induction motor). It seems to work well, but my initial cuts have a severe snipe on the leading edge
I'd like to be sure that I can set it up properly. Can anyone please point me in the direction of general setup instructions for this type of machine?
Thanks in advance