Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
13th February 2019, 12:04 PM #1Senior Member
- Join Date
- Oct 2018
- Location
- Melbourne
- Posts
- 128
Boxing up LVL beams with nice timber - ideas and advice please
Hi folks,
I’m building a cathedral ceiling that has three 6m LVL beams. I’d like to dress these in timber but I’m not sure about the best way of going about it.
ceiling.jpg
The ridge beam appears smaller, so I’ll have to frame out the ridge so that all 3 beams will appear to be of the same size when finished (something like this for the ridge beam):
cross-section.jpg
Given there’s not much for the battens to grab onto on the ridge beam (maybe 50mm), I’m guessing the battens will need to be decently screwed into the beam.
The aim would then be to clad the frame in thin hardwood all around.
My questions are:
- Would this be a suitable framing method for boxing up the LVLs?
- What timber would be suitable for the battens and bottom plate? It’ll need to support hardwood boards.
- What’s the thinnest hardwood boards that one can readily obtain from sawmills and such?
Thanks in advance,
Richard
-
13th February 2019 12:04 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
14th February 2019, 12:02 PM #2GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 3,552
I'd just run a horizontal batten along each side of the beam. The boxing can then be made up as a U shape and fixed through the sides to the battens. If the boxing material is going to be less than 16mm thick a batten in the bottom of the U will be required. This could be fabricated at ground level using glue rather than metal fixings and the whole thing would resemble one piece of wood when slipped up into position.
-
14th February 2019, 01:57 PM #3Senior Member
- Join Date
- Oct 2018
- Location
- Melbourne
- Posts
- 128
-
14th February 2019, 06:30 PM #4GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 3,552
That's right, just make up the boxing to the required dimension and it hangs directly off the battens on each side of the beam. No need to frame it, its not carrying anything other than itself. If the boxing is going to be super thin material then a packing piece will be required in the bottom of the U for fixing the sides of the boxing to the base, whether glued,nailed or screwed. The thinner the material the boxing is made from will reduce both cost and weight. Weight is an important consideration if you intend to fabricate and then lift into position. Easiest way is to knock up a couple of tee tombs reaching from your scaffold to the underside of the boxing, lift the boxing into position and slide a tomb under each end. Now your free to fasten the box to the beam at your leisure.
Similar Threads
-
Advice - timber and ideas for window making
By LucasT in forum TIMBERReplies: 2Last Post: 2nd January 2019, 07:59 AM -
Retaining wall ideas - Universal beams instead of sleeper posts?
By Reno RSS Feed in forum RETAINING WALLSReplies: 0Last Post: 8th December 2009, 01:40 PM -
Retaining wall ideas - Universal beams instead of sleeper posts?
By Reno RSS Feed in forum RETAINING WALLSReplies: 0Last Post: 6th December 2009, 11:10 PM