Thread: Who flogs these bead bits ?

McJING Tools Online

Full Bead Bit : CARBA-TEC

thanks..... by the looks of it......to get the 1/8" radius I'll have to get a multibead.

Jake, have you thought of using a scratchstock? could be the go if you cant get the cutter you want.

thanks alex. scratchstock is what I use normally. like this sort of thing.

probably what I'll end up using anyway, but I find they can be a bit tricky across end grain. tear a bit. and much much slower to use.

but then its kinda tricky getting a similar profile with a router bit I spose...dont' want that wider flat at the bottom of the groove routers tend to leave. had an idea to grind it finner but then it might be wide for a reason, and burn...

idon'tknow.

If you give these guys a call I'm sure they will be able to help.
CARB-I-TOOL
Even if it is a custom job. They make the bits for Roger Gifkin.
All the best
Kevin

Thanks Kevin,

found the one I'm after in that carbitool link. 'draw line bit '.

thanks for all the help. ta.