Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Refinish polyurethane table top
-
23rd August 2023, 03:47 PM #1GOLD MEMBER
- Join Date
- May 2009
- Location
- melb
- Posts
- 1,125
Refinish polyurethane table top
I want to refinish a table top which was finished with polyurethane. Looking at the colour, it looks like an oil based finished and could be 2 pack given that the table was used in an commercial application. Im worried that sanding it would be a pain to do - I have a 100mm wide makita belt sander with 40 and 80 grit paper and festool ROS with 5mm orbit with 80grit lowest grit paper I have. Should I be using something like paint stripper instead? Ive heard that people do that, but how do you manage the paint stripper that gets absorbed by the timber?
-
23rd August 2023 03:47 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
25th August 2023, 04:14 PM #2
I have had good results with a tungsten scraper. Four tricks are:
- Insert a 1 metre broom handle - aids control,
- Round over the corners of the blade before you start - stops gouging,
- Keep the blade sharp - diamond file essential,
- Follow the grain assiduously - first deviation and you'll know why!
Tungsten Scraper 2.jpgTungsten Scraper.jpg
Side grain is relatively easy with care. End grain is difficult. You need absolute control of the cutter, and the cleaned surface remains much darker - presumably because it has absorbed more poly? Joints need real care because of changes in grain direction.
I got reasonable results with a heat gun - both gas and electric - and with stripper - gel first, then liquid. But in both cases I had to use a scraper to finish.
A ROS gave tolerable results but a lot of work - poly is tough. My old Rupes orbital sander left indelible sanding swirls.
My big brutish Makita belt sander was too hard to control. Glossed over "good poly" and dug into exposed timber.
Most experience has been with one pot Estapol, a little with very old two pot Estapol.
-
28th August 2023, 08:56 PM #3Intermediate Member
- Join Date
- May 2021
- Location
- Armidale
- Age
- 60
- Posts
- 30
Sanding should be okay but I would avoid 40 grit, way to aggressive. You'll clog a lot of paper but I prefer to stay away from any chemicals and heat guns give off a lot when they get at poly.
Similar Threads
-
Removing wax to refinish with polyurethane
By AndrewPatrol in forum FINISHINGReplies: 4Last Post: 11th November 2021, 10:36 PM -
Best way to refinish a weathered outdoor table.
By anythingbutpine in forum FINISHINGReplies: 9Last Post: 15th February 2012, 09:00 AM -
Oak Table Refinish / Restore
By padkison in forum FINISHINGReplies: 3Last Post: 7th February 2008, 06:06 AM -
How to refinish this table
By jmk89 in forum FINISHINGReplies: 14Last Post: 3rd January 2008, 11:52 PM -
Table refinish...
By surfdabbler in forum FINISHINGReplies: 14Last Post: 14th April 2007, 09:02 PM