Thread: Trial sharpen tablesaw blade, with a tablesaw...

I don't think a more expensive blade will give you a better finish. Saw blades are designed to cut, not polish, and they need to be pretty coarse to do that effectively

Well done, why buy another diamond disc, you can't fix what ain't broke. The only thing I can think of is changing the pivot relationship to the diamond disc to allow for different rake angles that blades can be bought with. This or a similar jig could also be used to change the top profile of the teeth is needed.

Thanks

The diamond blade I chose can chip the TC teeth if I go too hard/too fast.

When looking via 20x magnification the grind is very coarse compared to original.
A finer diamond blade may reduce the chance of chipping the edge of the TC teeth.
But, so does talking your time

Fortunately, the rake on most of my blades is constant, even though the number of teeth isn't.

Good point though.

Why not just get a proper diamond sharpening wheel?

Originally Posted by Bohdan

Why not just get a proper diamond sharpening wheel?

Cos one big enough to use in a table saw will likely cost a fortune, if you can even find one. They're usually only 4-6" diameter.

Well done.

Originally Posted by graham.murfett

I reckon, if I buy a much higher quality diamond blade I should get even better results. The trial blade i bought was a tile cutting blade.

I don't think it's a quality issue but more of a grit issue because it sounds like you are using a cutting wheel which has a very coarse grit.

What you need is a grinding wheel that comes in a very wide variety of sizes (4" to 12") and finer grits and they don't cost a bomb.

SWMBO uses a wide range of diamond grit wheels (from about 60 grit to 1200 Grit) for her lapidary work so I managed to sneak a few 180grit wheels onto her order.
We get her diamond wheels from thk.hk

I have one of the 180g diamond wheels mounted on an bench grinder to shape TC bits for my MW lathe and router bits.
I would easily be possible set it up for TS CT tipsharpening but a larger table would need to be setup to hold the blade.

Speed is another issue to consider

From Ukam.com.

The best speeds for diamond wheels for grinding carbide is between 5,000 to 6,000 surface feet perminute. Slightly higher are not detrimenta.l, particulary if a flood of coolant is applied and grindingpressure minimized. Table traverse rates of 100" to 500" per minute with cros feeds of .030 to .060may be used. The diamond wheel may be used with down feeds of .125" when hand fed across thework. For general surface grinding operations, down feeds should not exceed .001 per pass, forrougher grits and .00025 should be used for used for finish grinding or with fine grit wheels.

Note how little TC should be removed per pass, if you push too hard the diamond will wear/break off

If your TS saw is running the blade arbor at 3000 rpm then the surface speed on the outer edge of 9" wheel will be ~7100 FPM.
Many TS run higher than 3000 rpm at the arbor, with some running as high as 4200 rpm this would mean a surface speed of nearly 10k FPM which will be too high.

If you were to get a larger wheel bear in mind that this will increase the FPM.

I have often pondered ways of DIY circular saw sharpening, never thought about doing it your way. If I were to duplicate your system I would incorporate a maggy lamp type of magnifying lamp attached to the table saw top so that the geometry of the teeth could be matched to the diamond blade. My eyesight isn't what I would like it to be!

Good luck with your experiments.

Alan...

Very clever trick. Very clever. That diamond blade doesn't owe you a penny.