Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: where to get drill bit holder?
-
15th August 2006, 07:47 PM #1Senior Member
- Join Date
- Jun 2005
- Location
- Sydney
- Posts
- 295
where to get drill bit holder?
Hey guys,
I am after a drill bit holder. Ie a box/tray thingy that has all the holes for each size drill bit, and u stand the drill bit up in it! i hope u know what i am talking about!!
Bunnings have a round one, but i m hoping to find a rectangular one and cheap would be good too!
also it needs to be metric!
so has anyone seen one around?
Cheers
-
15th August 2006 07:47 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
15th August 2006, 07:53 PM #2
Just get a piece of timber the size and shape you want, use the drill bits you have to drill the holes and they will fit perfectly.
Cheers, Jack"There is no dark side of the moon really. Matter of fact it's all dark."
-
15th August 2006, 08:43 PM #3Senior Member
- Join Date
- Jun 2005
- Location
- Sydney
- Posts
- 295
i have done that before, but i have found that the drill bits fit really tightly. thast the main reason i want to buy one instead. But that may be my best bet!
-
15th August 2006, 08:58 PM #4
You could drill holes with all the bits you have and then put each bit in the next size up hole.
Put the 10mm in the 10.5mm hole, the 10.5mm in the 11mm hole etc.
This will work for all but your largest drill bit for which you will not have a larger hole
They may have been tight previously because of the wood swelling.
If this is the case, buy a cheap plastic cutting board, cut it into multiples of the final size you want the block to be, stack and glue/screw them together then drill the holes in that.
Cheers, Jack"There is no dark side of the moon really. Matter of fact it's all dark."
Similar Threads
-
Drill bit sharpening.
By JDarvall in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 51Last Post: 26th March 2012, 01:23 PM -
Drilling holes in steel ... small then big?
By Sir Stinkalot in forum METALWORK FORUMReplies: 26Last Post: 4th March 2009, 08:33 PM -
Impact Drill - Damaging drill bits
By BassTeQ in forum HAND TOOLS - POWEREDReplies: 18Last Post: 9th September 2005, 10:16 PM -
Preparing chisel mortice drill and bit
By numbat in forum HAND TOOLS - POWEREDReplies: 6Last Post: 7th September 2005, 09:13 AM -
Sash window bit.
By Joshua in forum ROUTING FORUMReplies: 3Last Post: 6th February 2004, 07:08 PM