Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: GMC Table saw slots
-
15th December 2017, 05:27 PM #1Intermediate Member
- Join Date
- Apr 2012
- Location
- Kiama nsw
- Posts
- 32
GMC Table saw slots
I have a GMC t/s & have had good service from it but it has very narrow slots of only 1/4 inch.Is there any adjustment to widen these slots or do I replace the whole top Thanks in advance?
-
15th December 2017 05:27 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
16th December 2017, 02:15 PM #2
Not sure why you want wider slots but if you explain what you want to do perhaps someone will have answers. If it is to run a sled then that can be made with rails that run against the side edges of the table.
Regards
John
-
19th December 2017, 06:10 PM #3Intermediate Member
- Join Date
- Apr 2012
- Location
- Kiama nsw
- Posts
- 32
@ orraloon.Hi John, thank you for the input re wider slots.I should have mentioned previously they are Tee slots which are 1/4 inch wide (top) not your normal
3/4 inch mitre slots.Looks like
I'll be replacing the entire t/s top including the required slots,a new fence & I will enquire about installing a new more powerful motor while I'm on the job.Thanks again & best wishes,James
Similar Threads
-
Table Saw Blade with Flat Cut for Slots
By meherenow7 in forum TABLE SAWS & COMBINATIONSReplies: 2Last Post: 9th September 2015, 10:21 AM -
Mitre slots in GMC table saw.
By fanlee in forum TRITON / GMCReplies: 1Last Post: 29th March 2014, 06:42 PM -
T slots in Mill Drill table
By morrisman in forum METALWORK FORUMReplies: 1Last Post: 3rd September 2011, 12:12 PM -
Mitre 1000SE. My table slots don't fit.
By RichardL in forum INCRA JIGSReplies: 23Last Post: 18th November 2007, 03:51 PM -
WC2000 Table Slots
By Alix in forum TRITON / GMCReplies: 3Last Post: 26th July 2003, 05:30 PM