Thread: Triton TRA001 Router.

Originally Posted by planemaker

Thanks Brett. With your current set up can you get any above table projection with the height of the collet.

Yes, the 12mm thick allows for above the table collet undoing (just).

Originally Posted by FenceFurniture

Yes, the 12mm thick allows for above the table collet undoing (just).

Thanks Brett.

Not always lol canberra is very hot in summer. Sorry about the wrong forum name

Originally Posted by Big Shed

His forum name here is Stuart

Thanks Fred. I will make contact with Stuart shortly.

Originally Posted by planemaker

Isnt it always cold in Canberra.

Only in the hearts of the inhabitants of the big white building on the hill.

Here here!

As Sir Delbs will attest, I've been on the warpath for a first class raising system for a very long time.

Its one of my favourite rants as to why we cant buy a motor-only router body like in the US. Then Id be a pig in mud with a super dooper lifter.

Originally Posted by Evanism

As Sir Delbs will attest, I've been on the warpath for a first class raising system for a very long time.

Its one of my favourite rants as to why we cant buy a motor-only router body like in the US. Then Id be a pig in mud with a super dooper lifter.

We can:
https://www.woodworkforums.com/184104...r-impressions/

You have to get a base with it, but at least it comes off to leave just the motor. Maybe a little underpowered, but frankly I think I'd rather avoid a router than can spin a 3" bit.

Not sure what lifts it will fit - I have jonly researched trying to get a fit to the Jessem Master Lift ii Excel which is a helluva piece of kit. Haven't purchased either part yet. I think what I'll do is send Jessem another email to see how their R&D is going for the mounts to suit the Bosch (which they said they were working on). It may be that I can get one to fit a larger dia router body and pack it out with hard rubber. Or summink.

Heres the kit I was talking about earlier thats compatible with the makita. Jessem Router Lift Prestige

It has a bunch of routers lifted at the base of the page that are compatible. I really really luke this kit. Im just wondering if its worth the purchase of another compatible router. This kit is $465

I have sent a pm to Stuart asking for feedback on how he was able to install the TRA001 to the Woodpecker Unilift.

Still awaiting a reply.

regards; Stewie.

Originally Posted by planemaker

I have sent a pm to Stuart asking for feedback on how he was able to install the TRA001 to the Woodpecker Unilift.

Still awaiting a reply.

regards; Stewie.

You might be better sending that as an email through the system - he may not have email notifications for PMs activated, and doesn't log in very often (I don't think). He has a very busy lifestyle with a demanding job.

Originally Posted by FenceFurniture

You might be better sending that as an email through the system - he may not have email notifications for PMs activated, and doesn't log in very often (I don't think). He has a very busy lifestyle with a demanding job.

Thanks Brett. I will do that now.

Stewie;

Originally Posted by planemaker

Thanks Brett. I will do that now.

Stewie;

Received feedback from Stu's Shed.

Stu's Shed | Murdering electrons in the woodworking workshop

Did that really answer your question???