Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Carba Tec Deluxe Suva Guard
-
20th April 2014, 07:46 AM #1
Carba Tec Deluxe Suva Guard
Does anyone have any feedback on this. I have a 10" Carba Tec Cabinet saw, and wonder if this would be a good option. I want to reduce dust in my shop as much as possible, especially when using sheet goods.
PaulLast edited by Jas The Master; 20th April 2014 at 07:50 AM. Reason: Can't Spell!
In memory of my Dad "Jas the Master Craftsman"
-
20th April 2014 07:46 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th April 2014, 08:29 AM #2.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,757
From the size of the hose used on it I can tell you it won't be very effective.
Have you read the recent stuff in the dust section on table saw guards?
Here is the link https://www.woodworkforums.com/f200/table-guards-dust-extraction-cuts-183791
There are photos and links there to other threads about how to tackle this issue.
There are 5 things that will need attention;
1) at least a 4" duct at the table saw guard,
2) 6" duct from the cabinet
5) 6" ducting all the way back to your dust extractor.
3) Dust extractor should be 3HP or more and located or venting outside your shed.
4) Most machines are severely throttled and you may need to take the angle grinder to them to open up a few holes so it can breathe better.
Unless all 4 are attended to, you simply won't get control of the dust generated by a TS.
-
21st April 2014, 03:25 PM #3SENIOR MEMBER
- Join Date
- Jul 2009
- Location
- inverloch
- Posts
- 472
An angle grinder sounds drastic. I used a jigsaw with a metal cutting blade on my table saw which i think gave me a bit more control.
-
21st April 2014, 05:05 PM #4.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,757
I agree about the control. It's also easier to run the jigsaw up against a line using a piece of timber of steel held by a couple of clamps.
I used a Makita nibbler the other day at the men's shed to cut a 160 mm port into the side of a combination machine cabinet which was 2.5 mm thick plate steel. Boy did that nibbler make short work of that plate. It will also cut up to 6mm plate without skipping a beat. Only problem was it could not quite make the 80 mm radius turn in one pass so I had to spiral out onto the line multiple times.
Similar Threads
-
Fitting a router table to a table saw with a suva guard?
By Sir Stinkalot in forum ROUTING FORUMReplies: 2Last Post: 26th October 2013, 08:36 PM -
Suva TS Guard
By dazzler in forum HAND TOOLS - POWEREDReplies: 1Last Post: 21st February 2007, 11:03 PM -
Riving knife & SUVA guard for TSC-10HB
By monoman in forum HAND TOOLS - POWEREDReplies: 34Last Post: 27th August 2005, 03:19 PM