Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: MBS 300 blade issue
-
22nd November 2010, 04:20 PM #1New Member
- Join Date
- Dec 2007
- Location
- hamilton
- Posts
- 6
MBS 300 blade issue
Hi all,
I have a Mikkiway branded MBS300 for which I recently purchased a 305mm blade as the manual indicates a maximum blade dimension of 12 inches/305mm. When I lower the blade it remains some 20mm above the table. Is this normal? If not any idea what could be wrong?
thanks
-
22nd November 2010 04:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
22nd November 2010, 06:09 PM #2SENIOR MEMBER
- Join Date
- Aug 2003
- Location
- Wodonga
- Age
- 59
- Posts
- 707
My MBS300 is the Carbatec one. The blade sits about 5-10mm below the table when fully lowered. The box the blade came in says it is 300mm, but I have never measured it to check.
Not sure what your problem may be, but I would suggest something is not correct.
-
22nd November 2010, 06:43 PM #3New Member
- Join Date
- Dec 2007
- Location
- hamilton
- Posts
- 6
thanks Geoff, thought so. I've pulled the top off and adjusted the stop on the arbor arm to enable maximum lowering, but that only improved things slightly.
Similar Threads
-
Another Log On issue
By derekcohen in forum FORUMS INFO, HELP, DISCUSSION & FEEDBACKReplies: 13Last Post: 9th March 2009, 10:10 PM -
My Freud dado blade-issue
By redlaci2004 in forum WOODWORK - GENERALReplies: 4Last Post: 5th June 2008, 09:42 PM -
Bandsaw Blade Issue
By Steve Zipperman in forum WOODWORK - GENERALReplies: 19Last Post: 21st December 2005, 10:38 PM -
OH&S issue
By AlexS in forum NON WOODWORKReplies: 6Last Post: 4th October 2003, 04:06 PM