Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Pulley for table saw
-
17th June 2016, 01:04 PM #1well aged but not old
- Join Date
- Sep 2004
- Location
- Brisbane
- Posts
- 925
-
17th June 2016 01:04 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
17th June 2016, 01:14 PM #2
Have you tried a bearing supplier? Most stock a wide range of pulleys or can order a special size.
There are also a wide range of pulleys listed on Ebay.
Apart from the dimensions you show in the photos you also need the diameter of the centre hole for the shaft to fit in.
-
17th June 2016, 02:40 PM #3
Trade Tools used to sell the saw. Perhaps they have a dust covered box with one?
-
18th June 2016, 10:47 AM #4
These guys should be able to supply one for you. There is a map on the site where you can find your closest dealer.
They are a Poly V pulley and by the dimensions you give would be a J section. As Fred says you will need the bore size, or if it is not standard you will need it to be bored or reamed out to size.
-
18th June 2016, 12:26 PM #5well aged but not old
- Join Date
- Sep 2004
- Location
- Brisbane
- Posts
- 925
Dear Treecycle
I will contact them on Monday. I want to get the saw going and sell it. It is a really good saw but I have my eyes on something much bigger.My age is still less than my number of posts
-
18th June 2016, 02:29 PM #6
My table saws' drive pulley was made by Stenco, they're still going:
STENCO | DIE CASTINGS PTY LTD
-
8th July 2016, 05:57 PM #7well aged but not old
- Join Date
- Sep 2004
- Location
- Brisbane
- Posts
- 925
I went to BSC at Stapleton (near where I live, South of Brisbane) on Wednesday. The people there actually tried to give me some help. One of them got on the phone and in 5 minutes located a pulley (with a taper bearing) that was just what I needed. Very good work. Also thank you to the people who responded to my request for help. Much appreciated.
My age is still less than my number of posts
Similar Threads
-
In need of a pulley.
By Maladay16 in forum WOODTURNING - GENERALReplies: 6Last Post: 13th August 2012, 08:48 PM -
Pulley Modification
By Anorak Bob in forum METALWORK FORUMReplies: 14Last Post: 29th January 2011, 07:29 PM -
Pulley sizes vs RPM?????
By OGYT in forum WOODTURNING - GENERALReplies: 19Last Post: 20th November 2008, 12:15 PM -
Wood to use for pulley?
By rotorque in forum TIMBERReplies: 18Last Post: 10th November 2005, 11:04 PM -
Drive Pulley's
By John Saxton in forum HAND TOOLS - POWEREDReplies: 3Last Post: 26th November 2004, 08:28 PM