Thread: Pulley for table saw

Have you tried a bearing supplier? Most stock a wide range of pulleys or can order a special size.

There are also a wide range of pulleys listed on Ebay.

Apart from the dimensions you show in the photos you also need the diameter of the centre hole for the shaft to fit in.

Trade Tools used to sell the saw. Perhaps they have a dust covered box with one?

These guys should be able to supply one for you. There is a map on the site where you can find your closest dealer.
They are a Poly V pulley and by the dimensions you give would be a J section. As Fred says you will need the bore size, or if it is not standard you will need it to be bored or reamed out to size.

Dear Treecycle
I will contact them on Monday. I want to get the saw going and sell it. It is a really good saw but I have my eyes on something much bigger.

My table saws' drive pulley was made by Stenco, they're still going:
STENCO | DIE CASTINGS PTY LTD

I went to BSC at Stapleton (near where I live, South of Brisbane) on Wednesday. The people there actually tried to give me some help. One of them got on the phone and in 5 minutes located a pulley (with a taper bearing) that was just what I needed. Very good work. Also thank you to the people who responded to my request for help. Much appreciated.