Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: CT-508 Blade recommendations
-
8th May 2015, 11:12 AM #1Intermediate Member
- Join Date
- Nov 2011
- Location
- Perth
- Posts
- 38
CT-508 Blade recommendations
Gday all,
As mentioned in another post I recently picked up a CJ-508 20in thicknesser and was doing the final clean and calibration last night and when inspecting the blades found two large chips in the blades, I could probable get them ground out but just wanted some advice.
I'm based in Perth so does anyone know of anywhere to have the blades resharpened south of the river?
I'm also interested in looking at some new blades and this is where you advice would be very handy, HSS or TCT or other? Should I purchase local interstate or off the internet. I have a 6 in jointer think its the CTJ-150 that I build a jig for sharpening the blades that worked really well but don't think I can do the same over 20 inches.
Suggestions?
-
8th May 2015 11:12 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
Adelaide - Jointer Blade Sharpening Recommendations
By Sir Stinkalot in forum SHARPENINGReplies: 5Last Post: 12th February 2014, 06:27 PM -
Crosscut blade recommendations.
By Psych 101 in forum TABLE SAWS & COMBINATIONSReplies: 4Last Post: 4th June 2013, 10:33 PM -
WA Recommendations for thicknesser blade sharpening
By BobL in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 4Last Post: 7th May 2013, 10:59 PM -
Bandsaw Blade recommendations
By redgum in forum WOODTURNING - GENERALReplies: 27Last Post: 22nd October 2009, 01:53 PM -
Blade/Blade supplier recommendations
By Androo in forum SCROLLERS FORUMReplies: 9Last Post: 23rd July 2006, 12:10 PM