Thread: Dewalt DW735 - Can someone please explain when to use the Turret Stop -NOT how To

Hi all,

I've finally been able to take the time to setup a thru slide for my new DW735
I'm super happy with the finished product

Dewalt DW735 - instruction manual describes HOW to SET the Turret Stop
But NOT the when logic to use the Turret Stop

If you actually own and/or have actually used a Dewalt DW725
PLEASE
- can you post step by step scenarios
- on the different logic of when uses
the Turret Stop

NOT HOW to set/adjust it by copy pasting the manual instructions?

On my successful first test, I just set the Turret to the minimum number
and set the depth gauge to the material height +1mm.

Then run the work piece thru ( I didn't care if the blades engaged the first or first few times thru or not)
and adjusted the height -1/4 turn.
and repeat until the work piece is completed flat.

To clarify, I never re-adjust the Turret.

I'm a metric man!
Lucky the height gauge and the Turret Stop is in mm.


Thanks in Advance