Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Feed roller chain skipping
-
26th January 2019, 03:45 PM #1
Feed roller chain skipping
Hi guys, so I only just purchased a Woodman pt310 12" combination jointer in used condition, in thicknesser mode the feed roller chain is skipping, does anyone have this same machine or the jet which I think is pretty much the same, and know a way to tighten the chain? I can't really see an adjustment, or would i just take some chain links out.
Thanks. Dave.
Sent from my SM-N960F using Tapatalk
-
26th January 2019 03:45 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
26th January 2019, 04:40 PM #2China
- Join Date
- Dec 2005
- Location
- South Australia
- Posts
- 4,475
I don't have that machine although normally chain drives have an idler of some type to adjust, also could be that the sprockets or chain need replacing
-
30th January 2019, 10:39 AM #3Senior Member
- Join Date
- Oct 2010
- Location
- Drouin Vic.
- Posts
- 166
I have a new PT-260 unit that is essentially the same. I just checked and agree there is no sign of easy adjustment. I did notice the chain is quite loose but improves when the roller drive lever is engaged. On checking the manual it only says under "chain jumping" the remedy is to adjust chain tension. I therefore wonder if the chain tension adjustment is linked to the belts/motor adjustment?
Cheers,
Paintman
-
5th February 2019, 04:44 PM #4Senior Member
- Join Date
- Oct 2010
- Location
- Drouin Vic.
- Posts
- 166
I have just checked again and found by removing the top cover from the main drive section (located on the left hand top side )
it gives you access to the belt and chain drive where you will find a small adjustable idler that can be altered to change the chain tension.
Cheers,
PaintmanIMG_0809.JPG
Similar Threads
-
Freeby - small roller chain
By bollie7 in forum METALWORK FORUMReplies: 0Last Post: 7th June 2015, 07:14 PM -
Drum Sander- belt or roller feed? any preferences
By SuperTuck in forum GENERAL & SMALL MACHINERYReplies: 5Last Post: 1st January 2014, 10:45 AM -
thicknesser feed roller not contacting with timber
By Gaza in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 15Last Post: 31st December 2011, 12:25 AM -
Delta thicknesser feed roller
By graemet in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 3Last Post: 11th December 2010, 07:26 AM -
Replacing rubber feed roller
By Excess in forum HAND TOOLS - POWEREDReplies: 5Last Post: 24th January 2007, 11:25 AM