Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Hafco 380-A thicknesser problem.
-
17th June 2023, 09:51 AM #1
Hafco 380-A thicknesser problem.
I have had one of these for 30 odd years and it is starting to show its age by having the feed jumping out of gear. I can't even see how to get the covers off to see if anything needs replacing. Anyone had experience or advice?
-
17th June 2023 09:51 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
17th June 2023, 10:44 AM #2
Same model as this ?
Does anyone have a machine manual for a Thicknesser (Hafco T-380A)?
-
17th June 2023, 11:48 AM #3
-
17th June 2023, 11:51 AM #4
-
17th June 2023, 12:21 PM #5
The manual is good, experience is better, but thanks!
-
17th June 2023, 03:19 PM #6
We have the 20" Carbatec variant at the Bundaberg Woodworker's Guild; there's not a lot on that machine I haven't pulled off.
The Grizzly manual is good; actually I think it's better than the CT one...
The feed knob should only be pushed or pulled with the machine running. Firmly push and pull it through the whole range of movement a few times. If the knob is wandering in or out on it's own agenda then it's probably the little detent ball (item 520) has become jammed within the input shaft (523). Other potential causes are the detent spring (521) is shot or the mating detent on the gear (524) is flogged out.
Just found THIS carbatec page; your machine may closely resemble one of the these. In any case the gearbox parts are functionally the same.Last edited by Chief Tiff; 17th June 2023 at 03:26 PM. Reason: Bit more info
Nothing succeeds like a budgie without a beak.
-
12th October 2023, 04:02 PM #7
Finally stopped feeding altogether so I did the dreaded stripdown. I can see what you were referring to now CT, and the problem is not to do with detenting, but stripped teeth on the gear. Tried Hafco, but that particular gear has been superseded with a new system and is no longer available. Hafco recommended a gear manufacturer for a new one.
So, new gear/weld old gear and cut new teeth/ anyone wrecking one? Suggestions welcome!
Similar Threads
-
Hafco HM-46 z leadscrew problem
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 28th February 2019, 01:50 AM -
Problem With a Hafco HM-46 Mill/Drill.
By Jarh73 in forum METALWORK FORUMReplies: 28Last Post: 23rd July 2012, 11:51 AM -
Another Problem with my Hafco HM-46 Mill Drill
By Jarh73 in forum METALWORK FORUMReplies: 22Last Post: 12th April 2012, 08:16 PM -
Hafco wl-38 problem
By stuffy in forum WOODTURNING - GENERALReplies: 6Last Post: 28th July 2011, 07:37 PM -
Hafco T-382 thicknesser problem
By haosiliu235 in forum WOODWORK - GENERALReplies: 7Last Post: 10th January 2009, 10:09 AM