Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Makita N2012NB thicknesser issue
-
31st May 2017, 03:56 PM #1SENIOR MEMBER
- Join Date
- Nov 2007
- Location
- Victoria
- Posts
- 733
Makita N2012NB thicknesser issue
Work has a Makita thicknesser that winds up and down on one side a little bit but not the other. I've taken it apart and can see there is a bevel gear at the bottom of the vertical threaded handle rod that turns a horizontal rod (below the table) with a bevel gear to raise/lower the other side in unison. Problem is the bevel gear on the vertical rod isn't held on tight so won't spin along with the vertical rod/adjustment handle on top to then turn the horizontal rod and I can't see any way it ever was held tight. The horizontal gear has a key way which makes sense. The online parts diagram doesn't show any grub screws etc as far as I can see.
Has anyone had a similar problem ? I guess the set up is common to these lunchbox thicknessers ?
thanks
Sam
-
31st May 2017 03:56 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
31st May 2017, 08:29 PM #2Woodworking mechanic
- Join Date
- Jan 2014
- Location
- Sydney Upper North Shore
- Posts
- 4,470
This is the clearest picture I could find and it looks like there is a projection in the gear to fit into a slot in the shaft.
Buy Spare Parts for Makita 2012NB - Powertool Spares
-
1st June 2017, 11:24 PM #3SENIOR MEMBER
- Join Date
- Nov 2007
- Location
- Victoria
- Posts
- 733
Thanks Lappa. I cant see anything on the machine itself.....off to a repair centre I guess.
Similar Threads
-
Jet JWP13dx Thicknesser Issue
By Reyon in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 31st August 2016, 10:52 AM -
Delta thicknesser issue
By Chrism3 in forum WOODWORK - GENERALReplies: 0Last Post: 24th August 2015, 11:31 AM -
15" Thicknesser Starter Contactor Issue
By dwp in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 0Last Post: 14th July 2012, 12:13 PM -
Makita Thicknesser
By measure twice in forum GENERAL & SMALL MACHINERYReplies: 1Last Post: 19th April 2010, 11:49 AM -
Makita 2012NB Thicknesser
By LiliB in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 2Last Post: 3rd November 2008, 10:42 AM