Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
-
31st March 2019, 09:06 PM #1Intermediate Member
- Join Date
- Aug 2011
- Location
- Victoria
- Posts
- 41
Replacing Sprocket Carbatec Thicknesser
Its an older 1994 16" model, on the right side under the cover are three sprockets, 2 large one small just below the chain tension.I have to remove and replace this smaller lower sprocket and i'm uncertain about backing off and re setting the tension part
Appreciate some help
Savman
-
31st March 2019 09:06 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
1st April 2019, 01:03 PM #2
Do you have a photo of the sprocket arrangement with the cover off? Normally there is very little if any tension on the drive chain for the feed rollers if that is the one you are referring to.
Dallas
Similar Threads
-
Carbatec CTJ-340 Thicknesser
By Dicky Knee in forum MANUALSReplies: 5Last Post: 22nd September 2019, 10:29 PM -
Replacing oil in 15" thicknesser gearbox.
By StevenManos in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 10Last Post: 6th February 2019, 11:19 AM -
QUEENSLAND Carbatec Thicknesser
By newqlder in forum WOODWORK - Tools & MachineryReplies: 8Last Post: 26th October 2018, 09:03 PM -
Replacing Ozito thicknesser blades. How?
By munruben in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 1Last Post: 6th May 2013, 08:10 PM -
Carbatec thicknesser
By fletty in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 4Last Post: 30th May 2005, 11:49 PM