Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
14th July 2018, 10:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,425
Welder about to go out the window
Hey guys im back asking again about setting up the welder going thru working out the possibly 100 settings i have had enough and about to sell the machine and buy one with digital readouts
is there anyway of adding a amp meter to my Italco 185I that will read the actual welding voltage before i weld rather than during my weld? obviously i need my eyes to look at the weld pool while im welding so i cannot look at the mutlimeter tapped into the polarity terminals i tried setting up a camera but its a major tussle camera went flat after i set everything up
i have seriously had enough i cannot weld like this and i can't work out my settings
the plan was to look back thru my video of the multimeter using my hand to break the video into sections for volts A,B,C,D etc... than write it all down inside the welders lid
just seems like its all fighting me
if i could set up a amp meter i could just dial in my voltage than work out my feed that would be very easy, but this whole measuring the voltage while welding at the same time is difficult
Read the full thread at metalworkforums.com...
-
14th July 2018 10:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many