Hey guys im back asking again about setting up the welder going thru working out the possibly 100 settings i have had enough and about to sell the machine and buy one with digital readouts

is there anyway of adding a amp meter to my Italco 185I that will read the actual welding voltage before i weld rather than during my weld? obviously i need my eyes to look at the weld pool while im welding so i cannot look at the mutlimeter tapped into the polarity terminals i tried setting up a camera but its a major tussle camera went flat after i set everything up

i have seriously had enough i cannot weld like this and i can't work out my settings

the plan was to look back thru my video of the multimeter using my hand to break the video into sections for volts A,B,C,D etc... than write it all down inside the welders lid

just seems like its all fighting me

if i could set up a amp meter i could just dial in my voltage than work out my feed that would be very easy, but this whole measuring the voltage while welding at the same time is difficult


Read the full thread at metalworkforums.com...