Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: 2M542 Driver
-
3rd February 2015, 11:13 AM #1Member
- Join Date
- Oct 2012
- Location
- warrnambool
- Posts
- 77
2M542 Driver
Hi there, is there anyone out there using the 2M542 drives in their cnc machines, If you have had problem with it loosing steps and not changing direction.. or just acting erratically, I would like to hear from you regarding the cause or problem, I have been running these drivers for about two years now and have had no problems with them until about a week ago, at the moment it is only the Y axis that's doing it, I have swapped motors around and they are fine, could it be a stray signal problem somewhere or something like that?
Regards
Nick
-
3rd February 2015 11:13 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
3rd February 2015, 06:32 PM #2
Broken wire in the cable chain ,will cause random y axis movements
how come a 10mm peg dont fit in a 10mm hole
-
3rd February 2015, 10:49 PM #3Member
- Join Date
- Oct 2012
- Location
- warrnambool
- Posts
- 77
Thanks for the advice Sawdustsniffer, I have tested everything but the cable connections, will try them tomorrow.
Similar Threads
-
CNC driver
By morrisman in forum METALWORK FORUMReplies: 0Last Post: 8th August 2014, 12:15 PM -
what drill driver/impact driver combo kit?
By george96 in forum HAND TOOLS - POWEREDReplies: 9Last Post: 26th April 2011, 11:25 PM -
van driver
By Tonyz in forum WOODIES JOKESReplies: 1Last Post: 27th September 2007, 12:43 AM