Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: CNC Machine Problems
-
14th October 2013, 05:51 PM #1Novice
- Join Date
- Jun 2013
- Location
- AUSTRALIA
- Posts
- 21
CNC Machine Problems
Hi All,
New to this part of the forum. Have almost finished building my 2.4mx1.2 metre rig but having some troubles. Using Nema23 380oz 3.5A with the G540.
Im running ballscrews on all axis (x,y,z) with one on each side of the x axis. They are Chinese/Malaysian ones from linearmotionbearings(ebay).
Im not having any troubles when running them forward but in reverse they seem to keep "binding" up.
Ive tried tightening the nuts on the end of the ballscrew but still experiencing the same issue. When i run the machine super slow it doesn't happen but still isn't very smooth. Not sure if greasing it all up well will help (also what grease should i be using)
Thanks All,
Ben
-
14th October 2013 05:51 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
15th October 2013, 07:36 PM #2Member
- Join Date
- Jan 2012
- Location
- Springfield Lakes
- Posts
- 60
Hi Ben
how are you driving the X axis? Are you using one stepper to drive both ball screws? If you disconnect the stepper motor and the gantry from the X axis ball nuts, are you able to turn each ball screw without any binding in both directions? Could it be the ball screws are misaligned to each other?
Craig
-
16th October 2013, 01:31 AM #3Novice
- Join Date
- Oct 2013
- Location
- Europe
- Posts
- 11
Hi Ben,
Check also the wiring connector on the stepper and the driver. I had the following concern with one axis on my machine. It was running quiet good in one direction and strugle in the other. I spent a lot of time to discover this junky connection one one single wire .
Similar Threads
-
United states machine tool co. #1 horizontal milling machine
By pmcgee in forum ANTIQUE AND COLLECTABLE TOOLSReplies: 0Last Post: 1st March 2013, 11:16 PM -
Problems
By Mrs Woodpecker in forum WOODTURNING - PEN TURNINGReplies: 3Last Post: 7th February 2013, 10:21 PM -
Help - CA problems
By Mobyturns in forum WOODTURNING - PEN TURNINGReplies: 11Last Post: 20th January 2013, 11:48 PM -
Problems with m3
By Bin57again in forum TIMBERReplies: 3Last Post: 2nd December 2010, 04:58 PM -
Convert manual machine into electric machine
By Tiger in forum COOKINGReplies: 4Last Post: 3rd March 2008, 01:47 PM