Thread: Common problems and solutions of CNC router

I wish I'd said that..

I wish i could say that

Q: When you open the software, the computer will prompt "Open the card failed, please check the concern".

Answer: 1 - Check whether the motherboard driver is installed or used for PCI slot replacement motherboard

.2 - Reinstall two data connections to check for broken needles

There is a problem with the 0.3 motherboard. Please replace the motherboard.

Q: Open the software when prompted: three-axis alarm, initial error four.

Answer: 1 - Check if the two data lines of the computer and the machine are connected

2- Check whether the fuse of the switch board in the control box is burned, replace the fuse 0.3

Check if the 5v12v power supply is normal.

: Dislocated size or not suitable for engraving

Answer: 1 Check if the path of the engraving software is correct

0.2 Check the clearance of the screw. Answer: 1 Check if the Z axis motor is normal.

Check if the software parameter settings are correct.

:. When the x-axis goes over a certain segment, z will not raise it and it will rise and fall. Adverbial clause:

Work, power and drive current size

0.2 Check if the shaft motor circuit is disconnected or broken.

Must be nice to speak and write Chinese, thanks for the translation.
Kryn

Why is this in the marketplace???


Mod edit - It is not in market place anymore

That's the longest cnc themed Haiku I've ever seen!

Mods are treating this as Not spam but are watching.

e...