Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
29th May 2019, 07:30 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
AXA100 type quick change tool post feedback?
Me again, sorry.
So, I have a Hercus 260 as some of you will know. New to turning, love it, I'm out there every evening after work having a go and getting the hang of it.
'Turning is learning' but bloody hell I seem to spend a lot of time farting around changing tools with my standard setup...out with one, in with the other, check, shim, next operation, do it again...ugh.
I see that AMWH has adaptor studs available for the AXA 100 type quick change tool posts. And I see that these tool posts are available all over the place for not much cash, from the standard Chinesium online stuff to H&F (that is likely the same).
Are you using one of these? What do you think?
Also, I see that the AXA 100 tool holders have capacity for only a 14mm max tool. One of my favourite tools is a WNMG that is 16x16mm and I don't see any that are smaller than this. Would I be better off with the bigger capacity AXA 200?
Pardon my ignorance...
Moz
Read the full thread at metalworkforums.com...
-
29th May 2019 07:30 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Quick change tool post advice
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 19th November 2018, 11:11 AM -
Quick change tool post
By TKO in forum METALWORK FORUMReplies: 5Last Post: 20th October 2013, 10:15 PM -
quick change tool post help
By Aerohydro in forum METALWORK FORUMReplies: 5Last Post: 23rd April 2012, 12:11 AM -
quick change tool post
By scratchbuilt in forum METALWORK FORUMReplies: 18Last Post: 13th March 2012, 07:46 PM -
Quick Change Tool Post
By tinkera in forum METALWORK FORUMReplies: 3Last Post: 22nd September 2010, 11:17 AM