Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
1st November 2018, 04:30 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,425
Hercus 260G spindle wrench modification
Made a small modification to my lathe. I know a circular engagement with the spindle isn't ideal, but it was the easiest to make at this point in time.
Gets the job done, sits nice and snug in the back of the spindle. Now the chuck can be removed without having to go into low gear and risking damage to the gears, etc.
It is now similar to the spindle on the Emco V10 P.
And yes that small 8mm bolt is enough to do the job, I could probably use the wrench as a hammer if need be.
45088622_890429737820140_2761576023282679808_n.jpg45134475_2306606286036149_6629116918538174464_n.jpg45170234_609757519469923_3671825884186148864_n.jpg45227972_268845850439569_277989426066358272_n.jpg
Attached Images
- 45170234_609757519469923_3671825884186148864_n.jpg (240.5 KB)
- 45227972_268845850439569_277989426066358272_n.jpg (253.9 KB)
- 45088622_890429737820140_2761576023282679808_n.jpg (251.7 KB)
- 45134475_2306606286036149_6629116918538174464_n.jpg (40.0 KB)
Read the full thread at metalworkforums.com...
-
1st November 2018 04:30 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
hercus 260g sold $7000
By MWF FEED in forum THE HERCUS AREAReplies: 0Last Post: 28th September 2018, 08:40 PM -
Hercus 9 Spindle Lock
By MWF FEED in forum THE HERCUS AREAReplies: 0Last Post: 22nd December 2017, 01:50 PM -
Hercus Craftsman Spindle Help!
By anj909 in forum THE HERCUS AREAReplies: 2Last Post: 3rd February 2015, 07:54 PM -
HERCUS 260G
By Jeff 8 in forum THE HERCUS AREAReplies: 5Last Post: 24th July 2014, 10:39 PM -
Hercus 260 spindle bearings available
By jb1248 in forum THE HERCUS AREAReplies: 1Last Post: 14th February 2012, 02:05 PM