Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Hercus 9 operation help
-
28th April 2024, 03:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,450
Hercus 9 operation help
Have been playing with my Hercus 9 & now understand some of the basics.
Have noted that when threading I can disengage the half nuts very quickly "on the run" such as when threading up to a hard stop or groove.
BUT
If I'm not threading but machining up to a similar shoulder I can't see any comparable way to quickly stop the power feed. So far I've been switching the lathe off, waiting for it to stop, then disengage the power feed & hand feed to the shoulder.
Is there a better way?
Thank you, Graham
Read the full thread at metalworkforums.com...
-
28th April 2024 03:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Appendix Operation
By KBs PensNmore in forum WOODIES JOKESReplies: 1Last Post: 23rd May 2020, 07:40 PM -
Air Tool Operation
By Oldneweng in forum METALWORK FORUMReplies: 14Last Post: 5th August 2013, 08:33 PM -
Slitting Saw Operation
By electrosteam in forum METALWORK FORUMReplies: 16Last Post: 12th January 2010, 10:23 AM -
Allan's Operation
By Barry Hicks in forum WOODIES JOKESReplies: 0Last Post: 7th June 2008, 02:44 PM