Thanks: 0
Likes: 0
Results 16 to 22 of 22
Thread: Trim router bit
-
31st May 2023, 05:57 PM #16
What are You Trying to Do?
Good Morning Richard
You have me intrigued. You need a small bottom bearer straight cut router bit to cut into end grain using a trim router?
What are you making?
Perhaps a bit of lateral thinking is in order?
-
31st May 2023 05:57 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
31st May 2023, 10:59 PM #17GOLD MEMBER
- Join Date
- Apr 2013
- Location
- Sydney
- Posts
- 1,557
-
1st June 2023, 02:28 PM #18
Now I am even more intrigued, Richard, as I am not familiar with the radial finger joint.
Is it a variation on the Japanese sunrise dovetail, or something else?
Dovetail - Sunrise.jpg Japanese sunrise dovetail
Perhaps a photo or drawing might help?
-
1st June 2023, 03:08 PM #19GOLD MEMBER
- Join Date
- Apr 2013
- Location
- Sydney
- Posts
- 1,557
Graeme, there is pic in the wood turning section but to save you the trouble.
IMG_7852.jpg
-
1st June 2023, 04:14 PM #20
Thanks, Richard; I am not a turner so I had not come across this before.
We learn - I like the mallet - almost too pretty to use!
Amana make straight cutter router bits down to 3/16" (~4.76 mm) and with a 1/4" shaft.
https://www.amanatool.com/47222-miniature-flush-trim-plunge-template-3-16-dia-x-1-2-x-1-4-inch-shank-carbide-tipped-router-bit-with-mini-3-16-dia-upper-ball-bearing.html
Amana bit.jpg Amana 3/16" flush trim plunge template bit.
And there are smaller ones available to fit dremels.
-
1st June 2023, 05:08 PM #21GOLD MEMBER
- Join Date
- Apr 2013
- Location
- Sydney
- Posts
- 1,557
Thank you, That’s absolutely perfect.
-
2nd June 2023, 07:42 AM #22GOLD MEMBER
- Join Date
- Apr 2013
- Location
- Sydney
- Posts
- 1,557
Similar Threads
-
Trim router
By Tonyz in forum ROUTING FORUMReplies: 5Last Post: 27th May 2022, 07:16 PM -
DONE: Ozito Trim Router, and mini router table
By poundy in forum SWAP OR FREEReplies: 1Last Post: 12th February 2021, 09:56 PM -
Trim Router advice
By Bernmc in forum ROUTING FORUMReplies: 170Last Post: 6th November 2020, 04:14 PM -
Does anyone have any tips for using a trim router to trim melamine edging?
By Tccp123 in forum WOODWORK - GENERALReplies: 12Last Post: 18th December 2018, 07:10 AM -
WANTED:QLD. Trim Router
By george mavridis in forum WANTED & WANTED TO BUY - in AustraliaReplies: 4Last Post: 7th June 2017, 11:33 PM