Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
12th November 2017, 07:16 PM #1
Whiteside 1/2" Shank Slot Cutter Arbor Missing Bearing Question?
Many moons ago I purchased a Whteside 1/2" Shank Slot Cutter Arbor plus some assorted cutters.
Today I unpacked them only to find that I am missing the ball bearing that sits between the cutter and the bottom of the thread.
So this maybe a stupid question however: Is there something special about the ball bearings used for router arbors or can I simple go to a ball bearing supplier and buy a suitable sized ball bearing to fit the arbor? I know that Whiteside sells replacement ball bearings but the postage would be stupid.
I cannot find the exact type of arbor that I have on the whiteside website, but it looks like this:
s-l500.jpg
-
12th November 2017 07:16 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
12th November 2017, 08:49 PM #2
Any double sealed bearing will do. Take the arbor with you. It should use a standard size bearing. If you get a few different sizes (outer diameter) you can change them to change the depth of the slot.
It may pay to check that the bearing is rated for the top speed of your router but it shouldn't be a problemThose were the droids I was looking for.
https://autoblastgates.com.au
-
12th November 2017, 09:03 PM #3
Cheers much appreciated
-
12th November 2017, 09:03 PM #4Woodworking mechanic
- Join Date
- Jan 2014
- Location
- Sydney Upper North Shore
- Posts
- 4,470
Carbitool do a selection of router arbor bearings if you have no luck locally.
CARB-I-TOOL - Router Bit and Accessories Catalogue - NOVEMBER 2015
-
13th November 2017, 09:47 AM #5
RPM shouldn't be a problem as most small bearings of a good quality brand will handle 30 to 40 thousand.
Similar Threads
-
Best slot cutter: Makita plate joiner or a router with a slot cutter bit ?
By harry wall in forum WOODWORK - GENERALReplies: 6Last Post: 24th July 2017, 08:18 PM -
19mm shank hole cutter adaptor
By dave4 in forum METALWORK FORUMReplies: 1Last Post: 19th February 2015, 07:48 AM -
Looking for a 3/16" x 1" woodruff slot cutter
By bob ward in forum METALWORK FORUMReplies: 10Last Post: 16th November 2014, 03:11 PM -
1/4" shank x 25mm+ cutting length straight bearing bits?
By d.m.s in forum ROUTING FORUMReplies: 7Last Post: 21st September 2014, 11:38 AM -
How to assemble a slot cutter to arbor
By JackD in forum ROUTING FORUMReplies: 5Last Post: 3rd January 2010, 09:26 AM