Needs Pictures: 0
Results 1 to 6 of 6
Thread: 150mm table saw dust port mod
-
5th November 2018, 03:14 PM #1SENIOR MEMBER
- Join Date
- Oct 2017
- Location
- Sydney
- Posts
- 148
150mm table saw dust port mod
Hi guys,
I finally got around to undertaking the mod on the table saw dust port from 100mm to 150mm.
I decided I didn't want to mod the existing back plate so made a new one out of scrap mdf.
I found that the DWV Bolted Trap Screw PVC Top 150mm worked perfectly as I bolted it straight into the mdf.
Essentially I removed the cap and used it as the flange to mount to the mdf.
I then used the expanded end of the 150mm pipe to insert the flex into it and it fits into the outlet as a slip fit.
I have carbatec 150mm flex which is slightly larger diameter than the expanded end of the pipe so I just cut a few slots which was enough to push the flex in. Duct taped it up and looks like it worked a treat.
Now off to do the jointer.
-
5th November 2018 03:14 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
5th November 2018, 06:43 PM #2.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,791
Pach, in this post I discuss ways of making those fittings a little more flow efficient.
Improving machine cabinet dust ports
May be worth doing if and when you next have to remove the fitting.
-
5th November 2018, 07:57 PM #3SENIOR MEMBER
- Join Date
- Oct 2017
- Location
- Sydney
- Posts
- 148
Thanka @BobL. I will give it a go.
Sent from my iPhone using Tapatalk
-
6th November 2018, 08:34 AM #4GOLD MEMBER
- Join Date
- Mar 2018
- Location
- Sydney
- Posts
- 1,166
@pach, out of interest where did you pick up the 150mm screw lid DWV fitting from?
-
6th November 2018, 11:33 AM #5SENIOR MEMBER
- Join Date
- Oct 2017
- Location
- Sydney
- Posts
- 148
@poundy, I just went to the local Plumbers Supplies Coop at Leichhardt and they had the 150mm ones in stock. Cost just over $10.
-
6th November 2018, 11:40 AM #6GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 7,696
Similar Threads
-
Dust port oddity
By LanceC in forum BANDSAWSReplies: 4Last Post: 21st September 2018, 04:09 PM -
Dust port on Wonderfence
By rtyuiop in forum INCRA JIGSReplies: 29Last Post: 3rd December 2017, 10:15 AM -
Ryobi ETS1526AL 240V 10-inch Table Saw - DUST PORT SIZE?
By IanG3145 in forum TABLE SAWS & COMBINATIONSReplies: 3Last Post: 18th March 2017, 03:09 PM -
New triton saw - dust port problem
By slowmo in forum TRITON / GMCReplies: 4Last Post: 2nd November 2010, 11:34 AM -
Dust port on a b/saw - anyone made one?
By Waldo in forum BANDSAWSReplies: 8Last Post: 24th August 2005, 02:16 PM