Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 18 of 18
-
20th March 2019, 08:15 AM #16
As I was posting it occurred to me you would lose cupboard space. Maybe only two cupboards.
Regards
PaulBushmiller;
"Power tends to corrupt. Absolute power corrupts, absolutely!"
-
20th March 2019 08:15 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
21st March 2019, 04:45 PM #17GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 3,559
How about having each machine mounted onto a board, with a pipe hinge at the rear edge. The bench has a continuous pipe of suitable OD to fit the hinge pipes ID and run the full length of the bench, approx mid way from front to back, between suitable height brackets. The machines are then able to be tilted up and down individually for use. A super clean area is not as critical as it would be for runners if the front edge of the machine bases had a built up edge and the brackets for the bench mounted pipe were set to the same height. Even if this was only 16mm it would mean a bench load of shavings could be left in place with just the front edge of the bench cleared for the front edge of the base being lowered.
I imagine a couple of bits of pipe would be a lot cheaper than runners.
-
21st March 2019, 05:47 PM #18
I think a combination of separate carts, housing two tools on flip tops, with storage below might just be the best of all worlds!
Like this perhaps - https://youtu.be/CCjpQen3LqQ
Cheers
Solly
Similar Threads
-
Jenssen Tool Room Equipment Cylindrical Square
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 23rd August 2018, 06:40 PM -
1951 Bench Plans - Cabinet Bench and Tool Cupboard
By chrrris in forum THE WORK BENCHReplies: 2Last Post: 5th June 2014, 09:00 AM -
Tool Drawers for easy access
By FenceFurniture in forum THE SHEDReplies: 21Last Post: 8th September 2012, 09:50 PM -
Paid for equipment - how long would you wait?
By adamtas in forum WOODWORK - GENERALReplies: 21Last Post: 1st November 2011, 07:07 PM -
Deceased Tool Maker's Equipment Sale
By Brko in forum ANNOUNCEMENTSReplies: 39Last Post: 25th October 2011, 11:59 PM